Filter
Top Products
6
➀
Mode Keys
Use these keys to program the remote
control and to select the operating
mode (VCR, TV, or AUX).
➁
Input Key
Press to select the program source to
be displayed on the screen: TV signal
or signal from the equipment you have
connected to the A/V jacks.
➂
Number Keys
Two keys must be pressed to select a
channel. Example: Press 0 then 6 to
select channel 6. For cable channels
100 through 125, press and hold the
1 key until C1–– appears. Then press
the other two numbers.
➃
Caption Key (See page 18.)
➄
Menu Key
Use this key with the / and
/ keys to navigate and adjust
features of the on-screen menu system
(see pages 9 ~ 11).
➅
Channel (CH) Scanning ( / )
and Volume ( / ) Keys
Press to scan through the channels in
memory and to adjust the volume.
➆
Mute Key
Press once to turn off the volume.
Press again to restore.
NOTE: When using the audio out jacks
this key will not mute the sound.
➇
VCR/DVD Keys
These keys control VCR and/or DVD
functions for Fast Forward ( ),
Rewind ( ), Play ( ), Record
(Rec) ( ), Stop ( ), and
Pause ( ).
➈
V-Guide Key (See pages 16 and 17.)
➉
Reset Key
Press this key twice to restore factory
settings. The TV will automatically
start Channel Search and clear all
customized settings. (See page 11.)
Power Key
Press to turn TV on or off.
Sleep Key
Use this key with the “0” key to set the
Sleep Timer (see page 15).
Recall Key
Select a channel then select another
channel using the number keys. Press
Recall to switch between the channels.
Display Key
Press once to display the channel
number and time. Press twice to
display the channel number
continuously. Press again to remove
the display.
PIP Keys (See pages 14 and 15.)
Point towards TV
11
12
13
UNIVERSAL/MULTIMEDIA REMOTE CONTROL KEYS
RECALL
DISPLAYMUTE
PLAY
PAUSE
SELECTLOCATIONSWAP
V-GUIDE
PIP
ON/OFF
REC STOP
MENU
CAPTION SLEEP
RESETINPUT
CH
VOL VOL
POWER
VCR TV AUX
QUIK FREEZE
123
456
789
0
123
456
789
0
➀
➁
➂
➃
➄
➇
➅
➈
➆
➉
12
13
14
14
11
15
15
QuickTips
■
Make sure batteries
have been installed
correctly.
■
If the remote control
does not work: Press
TVkey (see item 1).
■
The remote control
must be programmed
before it will operate
your VCR, Cable
Box, or DVD. See
pages 7 and 8.
■
Cannot select channel
with number keys.
Press “0” in front of
numbers 1 ~ 9.
Example: Channel 05.
■
The “C” in front of the
channel number indi-
cates a Cable channel.
■
Adjusting the volume
level: Right flashing
arrow indicates
volume is increasing
and left flashing arrow
indicates volume is
decreasing.
■
Channel number will
not display continu-
ously when captioning
is on.
■
Using V-Guide
TV Parental Guide-
lines settings can be
changed only by using
the Remote Control.
See pages 16 and 17.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
➠