Sanyo DVD-DX517 DVD Player User Manual


 
System Setup
2.3 DOLBY DIGITAL SETUP
2.3.1 DUAL MONO
STEREO: The player outputs the left-channel audio and right-channel audio via the FL and
FR speaker respectively.
Use the direction key [ ]/[ to select a speaker, center speaker, subwoofer, left surround
speaker or right surround speaker. Then use the direction key [ ]/[ ] to set the distance
difference.
L-MONO: The player outputs the left-channel audio only via both the FL and FR speaker.
R- MONO: The player outputs the right-channel audio only via both the FL and FR speaker.
MIX- MONO: The player outputs the average signal of the left-channel and right-channel
audio via the FL speaker and the FR speaker
NOTE: This function only applies to the Dolby AC -3 encoded 2-channel discs.
2. 3.2 DYNAMIC
When you watch films with large dynamic scope in low volume, for example at night, you can
adjust the dynamic value up to avoid losing sound details resulting from the low volume.
2.4 CHANNEL DELAY
This item is used to set the delay time for the center, rear speakers and the subwoofer. The
delay is to compensate for the audio propagation time difference caused by the distance
difference of the speakers to the listener.
]
-14-
2.5 EQUALIZER
2.5.1 SOUND MODE
Select a sound mode in this item.
2.5.2 BASS BOOST
Set it to ON to boost the bass sound.
2.5.3 SUPER BASS
Set it to ON to get the super bass sound effect.
2.5.4 TREBLE BOOST
Set it to ON to boost the treble sound.
NOTE:
The unit does not support delays for when the distance
between the center or surround speakers and the listener are
longer than that between the front speakers and the listener.
In case the channel delay settings cannot match your speaker
configuration, please set all distance difference to 0cm.
0cm
Sub
woofer