Sanyo DVD-DX517 DVD Player User Manual


 
-18-
Basic Playback
MP3 DISC PLAYBACK
Insert an nto the player, then a content menu will display on the screen.
MENU OPERATION:
Use the direction key [ ]/[ ] to select a folder or a file, then press [ENTER] to enter the
selected folder or play the selected file. You can also use the digit keys to make selection of a
folder to enter or a file to play.
In the content menu, press [ ] to return to the upper menu; press [ ]/[ ] to turn over to the
previous/next the menu page.
NOTE: During playback, [ ], [ ], [ ], [ ], [ ](press to stop the playback), [REPEAT], [A-B],
[VOLUME+/-], [MUTE], etc. are valid. Please refer to the remote control function introduction
for details.
MP3 disc i
[PROG]: Press repeatedly to switch between FOLDER mode and FILELIST mode.
Insert a USB drive in the USB port, then press [USB] to enter the connected USB drive and
you can playback the readable files in it. Press [USB] again to switch back to DVD mode.
In case the player breaks down when you insert a USB drive into the player, turn off the
player, disconnect the power cord from the AC outlet and unplug the USB drive from the
player. Then, power on the player again. The player will resume the normal status.
The connected USB drive is probably not a certified one. The player cannot play any
uncertified USB drive .
For playback operation, please refer to in this chapter.
NOTE:
MP3 DISC PLAYBACK
USB DRIVE PLAYBACK
Load a Disc
Press [OPEN/CLOSE] to open the disc tray.Insert a disc with the label-side up,then press
[OPEN/CLOSE] again to close the disc tray.
If a single-sided disc is inserted upside-down,the disc tray will open automatically,if not,the
unit will display “NO DISC”.
USB MEMORY DEVICE OPERATION
IMPORTANT INFORMATIONS
- Copyright protection files cannot be played back.
- Copyright protection files on the USB memory
device are skipped automatically when played
back.
- Recommended use:
Flash memory type USB memory player
- Not recommended:
Hard disc memory type USB player
- Some Flash memory player will not play
successfully with this uint.