Filter
Top Products
32 ST12450W/WD Installation Guide, Rev. B
2. Verify that all connections between the drive and the
host system are correctly installed.
2. Prüfen Sie, ob alle Verbindungen zwischen dem
Laufwerk und dem Host-System korrekt hergestellt
sind.
3. Verify that you have correctly installed jumpers (see
Figures 2, 4, 5, and 6).
3. Stellen Sie sicher, daß die Kennungsbrücken installiert
sind. Siehe Abbildung 2, 4, 5, und 6.
4. Connect the 50-pin SCSI cable into the drive’s SCSI
connector (shown earlier in Figure 1). Take care not
to stretch or crimp this cable, and do not block the
system’s cooling air flow with the cable.
The drive receives DC power through a 4-pin connec-
tor mounted next to the SCSI connector. The output
of a power supply must meet SELV (safety extra low
voltage) as defined in IEC 950. Figure 10 provides the
pin information for the DC power connector. To con-
nect the DC power cable to the drive, insert the cable
end into the drive’s DC power connector.
4. Schließen Sie das 50-polige SCSI-Kabel an den
SCSI-Steckverbinder des Laufwerkes an (wie bereits
in Abbildung 1 gezeigt). Das Kabel darf nicht gedehnt