Sears 50L5200U Flat Panel Television User Manual


 
112
Using the TV’s features
Displaying TV status information
When you turn on the Audio Receiver, change its input source or
adjust the sound volume, the sound will be output from the audio
receiver’s speakers even if TV Speakers has been selected. Turn the
TV off and on again to output the sound from the TV speakers.
Setting up HDMI
®
-CEC
To set the HDMI
®
-CEC Setup:
1 From the Setup menu, highlight HDMI
®
-CEC Setup and
press the ENTER button.
2 Press the ( / arrow) buttons to highlight Enable
HDMI
®
-CEC.
3 Press the ( / arrow) buttons to select On.
If you select Enable HDMI
®
-CEC Off, the other items will be grayed
out.
4 Press the ( / arrow) buttons to highlight the
HDMI
®
-CEC Setup item you want to use, and press the ( /
arrow) buttons to select On or the desired mode.
TV Auto Input Switch: On/Off
TV Auto Power: On/Off
Device Auto Standby: On/Off
Speaker Preference: TV Speakers/Audio Receiver
5 To save the new settings, highlight Done and press the ENTER
button.
To revert to the factory defaults, highlight Reset and press the
ENTER button.
Displaying TV status information
To display TV status information using the RECALL button:
Press the RECALL button on the remote control.
The following information will be displayed (if applicable):
Current input (ANT/CABLE, Video, etc.)
If ANT/CABLE is the current input, either “CABLE” (for
cable TV) or “ANT” (for over-the-air broadcasts).
Channel number (if in ANT/CABLE mode)
NOTE
NOTE