Filter
Top Products
220 VAC Intelligent Power Module Overview/Installation
For users that have purchased the 220VAC version of Remote Power On/Off, the Intelligent Power Module is a universal
design utilizing common IEC 320 connectors. Functionally, the IPM will operate the same as described earlier in the
110V IPM section, but will require modification of a multiple outlet/surge strip specific to your country and its outlet
type. Following is an illustration of the 220 volt version and installation instructions. By following these steps, the 220
VAC IPM can be adapted for use with any 200-250 VAC, 47-63 Hz country specific power strip.
IEC 320 Male
INPUT Connector
IEC 320 Female
OUTPUT Connector
5V DC LOGIC
SIGNAL INPUT
STATUS
I
NTELLIGENT
P
OWER
M
ODULE
0
TM
Step 1
Using a country specific PC power cable, attach the country specific end to a live outlet, then attach the opposite end
(standard IEC 320 /C13 connector) to the IEC 320 /C14 inlet on the IPM.
Toggle the rocker-type 0|1 switch to the ON (1) position - the green S
TATUS lamp will illuminate. This indicates the IPM
now has power and is ON. Toggle the switch back to the INPUT (0) position - the lamp will go out.
Remote Power On/Off Appendix A | 220VAC IPM • 39