Filter
Top Products
Power On/Off +Aux Control Unit
The desktop portion of Remote Power On/Off is the Power On/Off +Aux control unit. This unit monitors the telephone
line for RING, OFF-HOOK, and ON-HOOK conditions and signals the IPM to power the computer and peripherals on
and off accordingly.
TM
O
N
/O
FF
S
TATUS
ON/OFF
Master Power Switch - this square momentary-contact switch is used to manually control the ON/OFF signal
sent to the IPM, except when operating in the Reboot Mode. In the Power-ON or Infinite-On/Off operating modes, this
push button must be used to switch the computer on and off when operating the PC locally.
ON/OFF
LED - this green lamp indicates the status of the power signal to the IPM. A fully illuminated or flashing lamp
indicates a the power signal is ON. An off lamp indicates the power signal is OFF. See the 'On/Off and Status LED'
section of Appendix A for additional information.
S
TATUS LED - this green lamp will always be either flashing or fully illuminated when the Power On/Off unit is
operating. The flash rate of this lamp will change according to the current phone-line condition. It will also inform you
if the PC has been powered-ON remotely since it was last powered-OFF manually. See Appendix A for additional
information.
D
IP
S
WITCHES
L
INE
M
ODEM
A
UX
IPM P
ORT
P
OWER
DIP-S
WITCHES - these switches set the Operating Mode and configure all options. Changes become effective
immediately following any active calls.
Remote Power On/Off Product Overview • 9