Sharp 10P03-CH-NG Blu-ray Player User Manual


 
Before Starting Playback
Loading the Batteries in the
Remote Control
Hold in the tab on the battery cover and pull the
cover towards the direction of the arrow.
Load the two “AAA” size batteries (R-03 size,
UM/SUM-4). Place batteries with their terminals
corresponding to the m and n indications in
battery compartment.
Insert the smaller tab of the battery cover into
the opening 1, and press down on the cover
until it clicks in place 2.
NOTE
Do not subject the remote control unit to shock, water or
excessive humidity.
The remote control unit may not function if the Player's
remote sensor is in direct sunlight or any other strong light.
Incorrect use of batteries may cause them to leak or burst.
Read the battery warnings and use the batteries properly.
Do not mix old and new batteries, or mix different brands.
Remove the batteries if you will not use the remote control
unit for an extended period of time.
WARNING
Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or
catch fire.
It can also reduce the life or performance of batteries.
1
2
3
Connecting the Power Cord
Plug the supplied AC cord into the AC IN terminal on
the rear of the Player. Then plug into an AC outlet with
ground hole.
NOTE
Place the Player close to the AC outlet, and keep the
power plug within reach.
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT
TOUCH THE UN-INSULATED PARTS OF ANY CABLES
WHILE THE AC CORD IS CONNECTED.
The POWER indicator blinks while the Player is preparing
for starting up. You cannot turn the Player on until the
POWER indicator stops blinking.
If you are not going to use this Player for a long period of
time, be sure to remove the AC cord from the AC outlet.
Approximate operating range of
remote control
Playback
21
Playback
Remote control sensor
Remote control unit
30º 30º
Approx. 22 feet (7 m)
To AC IN terminal
To AC outlet
with ground hole