Filter
Top Products
54
Troubleshooting
Possible Solution
• Is the volume too low? (See page 20.)
• Have you pressed MUTE on the remote control unit? (See page 20.)
Problem
• No power
• Unit cannot be operated.
• Remote control unit does not
operate.
• Picture is cut off/with sidebar
screen.
• Strange color, light color, or color
misalignment
• Power is suddenly turned off.
• No picture
• No sound
• Check if you pressed POWER on the remote control unit. (See page 9 and page 51.)
If the indicator on the TV does not light up, press POWER on the TV.
• Is the AC cord disconnected? (See page 8.)
• Has the power been turned on? (See page 17.)
• External infl uences such as lightning, static electricity, may cause improper operation.
In this case, operate the unit after fi rst turning off the power of the TV or unplugging
the AC cord and replugging it in after 1 or 2 minutes.
• Are batteries inserted with polarity (
e
,
f
) aligned? (See page 9 and page 51.)
• Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fl uorescent lighting?
• Is a fl uorescent light illuminated near the remote control sensor?
• Is the image position correct? (See page 35.)
• Are screen mode adjustments such as picture size made correctly? (See pages 37
and 38.)
• Adjust the picture tone. (See pages 27 to 28.)
• Is the room too bright? The picture may look dark in a room that is too bright.
• Check the input signal setting. (See page 41.)
• Is the sleep timer set? (See page 36.)
• Check the power control settings. (See page 30.)
• The unit's internal temperature has increased. Remove any objects blocking vent or
clean.
• Is connection to other components correct? (See pages 15 and 16.)
• Is correct input signal source selected after connection? (See page 31.)
• Is the correct input selected? (See page 31.)
• Is picture adjustment correct? (See pages 27 to 28.)
• Is “On” selected in “Audio Only”? (See page 39.)
• Is a non-compatible signal being input? (See page 16.)
Troubleshooting-Digital broadcasting
The error message about reception of broadcast
• Failed to receive broadcast.
• Check the broadcast time in the program guide.
The example of an error message
displayed on a screen
• No broadcast now.
Possible Solution
• Check the antenna cable. Check that the antenna is correctly setup.
• The TV sometimes makes a
cracking sound.
• This is not a malfunction. This happens when the cabinet slightly expands and
contracts according to change in temperature. This does not affect the TV’s
performance.
Appendix