Filter
Top Products
18
Basic Adjustment Settings (Continued)
I/P SETUP
Adjusting the image and input signal can give you a more
beautiful picture.
Press MENU to display the Menu screen.
• The Picture Menu screen can be displayed directly by
pressing Red.
Press \/| to select “PICTURE”.
Press '/" to select “ADVANCED”, and press OK.
Press '/" to select “I/P SETUP”, and press OK.
0
0
0
COLOUR TEMP.
RED [ ] – +
GREEN [ ] – +
BLUE [ ] – +
I/P SETUP
DNR
FILM MODE
QUICK SHOOT
RESET
Press
'
/
"
to select “INTERLACE” or “PROGRESSIVE”,
and press OK.
INTERLACE
PROGRESSIVE
Press MENU to exit.
NOTE
•“I/P SETUP” cannot be set when 480P, 576P, 720P or 1080Ι
signal is received from the COMPONENT terminals.
DNR (Digital Noise Reduction)
DNR (Digital Noise Reduction) provides high quality images
with minimal dot crawl and cross colour noise.
Perform steps 1 to 3 in I/P SETUP to display the
“ADVANCED” screen.
Press '/" to select “DNR”, and press OK.
Press '/" to select “ON”, and press OK.
ON
OFF
Press MENU to exit.
NOTE
• “DNR” cannot be set to “ON” when 720P or 1080Ι signal is received
from the COMPONENT terminals.
4
5
6
Selected item
INTERLACE
PROGRESSIVE
Description
Use this setting when you cannot get a clear
picture with Progressive. (Especially suitable for
media with special effects like game software.)
Normally, you should select this setting.
1
2
3
1
3
2
4
FILM MODE
Automatically detects a film-based source (originally encoded
at 24 frames/second), analyses it, and then recreates each
still film frame for high-definition picture quality.
Perform steps 1 to 3 in I/P SETUP to display the
“ADVANCED” screen.
Press '/" to select “FILM MODE”, and press OK.
Press '/" to select “ON”, and press OK.
ON
OFF
Press MENU to exit.
NOTE
• Set “FILM MODE” to “ON” manually to detect a film-based source
(originally encoded at 24 frames/second) when the input source
has vertical frequency of 60 Hz (e.g. NTSC, PAL60).
•
“FILM MODE” cannot be set to “ON” when 480P,
576Ι
, 576P, 720P
or 1080Ι signal is received from the COMPONENT terminals.
•
Film mode does not work
when the input source has vertical
frequency of 50 Hz (e.g. PAL, SECAM).
QUICK SHOOT
Provides sharp pictures suitable for fast moving images such
as a sports programme.
Perform steps 1 to 3 in I/P SETUP to display the
“ADVANCED” screen.
Press '/" to select “QUICK SHOOT”, and press OK.
Press '/" to select “ON”, and press OK.
ON
OFF
Press MENU to exit.
NOTE
•“QUICK SHOOT” may cause image noise. If this occurs, set the
function to “OFF”.
4
1
3
2
4
1
3
2
LC-22GA3MX_E_P16-18.p65 04.8.25, 8:08 PM18