Filter
Top Products
16
Changing channels
You can change channels in several ways.
Simple operations for watching a TV program
Turning on the power
Press POWER on the TV, or POWER on the remote
control.
• POWER indicator (Green): The TV is on. (“PLEASE
WAIT” will appear for a few seconds on the screen.)
NOTE
• The LANGUAGE setup menu will appear automatically
when MENU is pressed on for the first time.
Turning off the power
Press POWER on the TV, or POWER on the remote
control.
• The TV enters standby mode and the image on the screen
disappears.
• The POWER indicator on the TV changes to Red.
NOTE
• If you are not going to use this TV for a long period of time,
be sure to remove the AC cord from the power outlet.
• Weak electric power is still consumed even when POWER
is turned off.
Preparation
Perform the following steps before you press POWER
on the remote control unit.
1. Insert the batteries into the remote control unit.
(See page 8.)
2. Connect the antenna cable to the TV. (See page
12.)
3. Plug in the AC cord to the AC outlet. (See page 7.)
Watching TV
NOTE
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• When you enter 0–9 only, channel selection will be made
if there is no operation within a few seconds.
To select a 3-digit channel number (e. g., Channel 115):
Press 1J1J5JENT
To select a 4-digit channel number (e. g., Channel 22.1):
Press 2J2J • (DOT) J1JENT
NOTE
• When you enter 0–9 only, channel selection will be made
if there is no operation within a few seconds.
• If you press 0 by itself in “AIR” reception, nothing will
happen.
• Complete the above steps within a few seconds.
• When you enter 0–9 and • (DOT), channel selection will
be made if there is no operation within a few seconds.
Method 1
Using CH
/ on the remote control unit or on the TV.
NOTE
• If your cable-TV system includes analog and digital
channels using the same channel number, your channel
up function will scroll through the analog channel first,
then the digital channel. Although it may appear as though
the channel does not change, it actually moves from the
analog to the digital channel in sequence.
If you use channel-down, it will move in reverse, from the
digital channel to the analog channel.
Method 2
Using remote control buttons 0–9, • (DOT) to select
channels for VHF/UHF/CATV/DIGITAL.
To select a 1 or 2-digit channel number (e. g., Channel 5):
Press 5JENT
Changing volume/sound
Changing the volume
You can change the volume on the TV or on the
remote control unit.
NOTE
• VOL+/– on the TV operates the same as VOL+/– on the
remote control unit.
Using VOL +/–
• To increase the volume, press VOL+.
• To decrease the volume, press VOL–.
POWER indicator
TV status indicator (POWER)
POWER
CH /
VOL - /+
ON Lighting (Green)
OFF/Standby Lighting (Red)