Filter
Top Products
7
Attaching/Detaching the Stand
• Before attaching (or detaching) the stand, unplug the AC
cord.
• Before performing work spread cushioning over the base
area to lay the TV on. This will prevent it from being
damaged.
CAUTION
• Attach the stand in the correct direction.
• Do not remove the stand from the TV unless using an
optional wall mount bracket to mount it.
• Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
Setting the TV on the Wall
CAUTION
• This TV should be mounted on the wall with both
the AN-37AG2 (SHARP) wall mount bracket and the
AN-37P30 (SHARP) attachment of the wall mount
bracket. The TV cannot be mounted when with
only the AN-37AG2 wall mount bracket. The use of
other wall mount brackets may result in an unstable
installation and may cause serious injuries.
• Installing the TV requires special skill that should
only be performed by qualifi ed service personnel.
Customers should not attempt to do the work
themselves. SHARP bears no responsibility for
improper mounting or mounting that results in
accident or injury.
Using an optional bracket to mount the TV
•
You can ask a qualifi ed service professional about
using an optional AN-37AG2 + AN-37P30 bracket to
mount the TV to the wall.
• Carefully read the instructions that come with the
bracket before beginning work.
QUICK REFERENCE
Vertical mounting Angular mounting
Hanging on the wall
AN-37AG2 + AN-37P30 wall mount bracket.
(See the bracket instructions for details.)
About setting the TV angle
• Detach the cable clamp on the rear of the TV when using
the optional mount bracket.
• Due to the terminal confi guration on this TV, when you
wall-mount this model, make sure there is enough space
between the wall and the TV for the cables.
• To use this TV mounted on a wall, remove the covers at
the 4 locations on the rear of the TV, and then use the
screws supplied with the wall mount bracket to secure the
bracket to the rear of the TV.
1
Confi rm that there are 12 screws (all the same size)
supplied with the stand unit.
2
1
Set the post for the stand unit onto the box.
2
Attach the base to the post.
3
Insert and tighten the 8 screws into the 8 holes
on the bottom of the base.
Hold the stand unit securely with one hand, and then tighte
n
the screws.
2
3
3
1
1
FRONT
Screws
3
1
Insert the stand into the openings on the bottom
of the TV.
2
Insert and tighten the 4 screws into the 4 holes
on the rear of the TV.
1
1
2 2
Screws
Soft cushion
• To detach the stand, perform the steps in reverse order.
•
0/5/10/15/20°
• The center of the display:
5
/
16
inch (7.9 mm) under the
“A” position.
• Refer to the operation
manual of 37AG2/AN-37P30
for details.