Filter
Top Products
11
Press MENU and the MENU screen displays.
1
Checking signal strength and
channel strength
If you install a DVB-T antenna for the fi rst time or
relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking
the antenna setup screen.
Preparation
Press
c
/
d
to select “Setup”.
2
Press
a
/
b
to select “Antenna Setup-
DIGITAL”, and then press ENTER.
3
w Checking signal strength
Press
a
/
b
to select “Signal Strength”.
Signal Strength
Supply Voltage
Channel Strength
Signal Strength
Quality
Current Max 0
CH No. 21
0
Current Max 0 0
w Checking channel strength
Press
a
/
b
to select “Channel strength”, and
then press ENTER.
Signal Strength
Supply Voltage
Channel Strength
Signal Strength
Quality
Current Max 0
CH No. 21
0
Current Max 0 0
2 6 5 . 2
MHz
Position and align the antenna so that the
maximum possible values for “Signal Strength”
and “Quality” are obtained.
4
NOTE
• The values of “Signal Strength” and “Quality” indicate when
to check the appropriate alignment of the antenna.
Press POWER on the TV.
• The initial auto installation wizard appears.
1
Setting the on-screen display language.
2
Press
a
/
b
to select the desired language,
and then press ENTER.
3
Initial auto installation
When the TV powers on for the fi rst time after purchase,
the initial auto installation wizard appears. Follow the
menus and make the necessary settings one after
another.
Confi rm the following before turning on the
power
• Is the antenna cable connected?
• Is the AC cord plugged in?
English
Digital Search
Major Analogue Channel settings are pre-set.
However, if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform “Auto Installation” in “Setup” section
(refer chapter “Watching TV” on manual).
Press ENTER.
4
The TV searches for, sorts and stores all
the receivable TV stations according to their
settings and the connected antenna.
• To abort the initial auto installation in progress,
press ENTER.
5
NOTE
• If you turn off the power on the TV after performing step 4,
the initial auto installation wizard does not appear. The auto
installation function allows you to execute the installation
again from the Setup menu. (Page 20)
• The initial auto installation wizard will go off if you leave the
TV unattended for 30 minutes before searching for channels
in step 5.
• Major Analogue Channel settings are pre-set.
However, if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform “Auto Installation” in “Setup” section (See
page 20).
65RX1X_en_c.indd 1165RX1X_en_c.indd 11 2008/06/20 13:58:162008/06/20 13:58:16