Sharp LC-52D64U Flat Panel Television User Manual


 
Supplied accessories
Attaching the stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it
from being damaged.
Attach the supporting post for the stand unit
onto the base using the box for the stand unit
as shown below.
The supporting post attaches to the base at
an off-centered location on the base. Be sure
to attach the supporting post in the direction
indicated below and attach the stand to the TV
with the wider side of the base facing forward.
CAUTION
Attach the stand in the correct direction.
Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
Confi rm that there are 8 screws (4 short
screws and 4 long screws) supplied with the
stand unit.
1
2
Hex key
Long screws
Forward
1
Insert the stand into the openings on the
bottom of the TV.
2
Insert and tighten the 4 short screws into
the 4 holes on the rear of the TV.
NOTE
To detach the stand, perform the steps in reverse order.
3
1
1
2 2
Hex key
Short screws
Soft cushion
QUICK REFERENCE
6
NOTE
Always use the AC cord supplied with the TV.
AC cord enclosed in this product is for 110-125V. In using it on the 125-240V AC, please consult to the following.
SHARP ELECTRONICS CORPORATION, LATIN AMERICA GROUP
6100 Blue Lagoon Drive, Suite 150, Miami, Florida 33126, U.S.A.
Make sure the following accessories are provided with the product.
Remote control unit
(
g
1)
Page 8
“AAA” size battery
(
g
2)
Page 8
AC cord
(
g
1)
Page 7
Stand unit
(
g
1)
Page 6
Cable clamp (
g
1)
Cable tie (
g
1)
Page 7
Operation manual
(
g
1)