Filter
Top Products
Preparation (Continued)
8
Antenna Connection
OUTDOOR ANTENNA CONNECTION
1. A 75-ohm system is generally a round cable with F-type connector that
can easily be attached to a terminal without tools (not supplied).
2. A 300-ohm system is a flat “twin-lead” cable that can be attached to a
75-ohm terminal through a 300/75-ohm adapter (not supplied).
• The antenna requirements for good color television reception are more important than those for black & white television
reception. For this reason, a good quality outdoor antenna is strongly recommended.
The following is a brief explanation of the type of connections that are provided with the various antenna systems.
ANTENNAS
75-ohm
coaxial cable
300-ohm
twin-lead
VHF/UHF
antenna
VHF/UHF
antenna
Pull down the hook
to open the cover.
300/75-ohm
adapter
(not supplied)
300-ohm
twin-lead
300-ohm
twin-lead
75-ohm
coaxial cable
IN OUT
VHF
antenna
UHF
antenna
Combiner
(not supplied)
or
or
ANT.
(Antenna
terminal)
A. Combination VHF/UHF antenna
B. Separate VHF and/or UHF antennas
Antenna Cable
(commercially available)
F-type connector should be finger-tightened only.
When connecting the RF cable to the LCD TV set, do not tighten F-type connector
with tools.
If tools are used, it may cause damage to your LCD TV set.
(breaking of internal circuit, etc.)
NOTICE
F-type connector
75-ohm coaxial cable (round)
300-ohm twin-lead cable (flat)
• Use one of the following two diagrams if you connect an outdoor antenna.
A: Using a VHF/UHF combination outdoor antenna
B: Using separate VHF and/or UHF outdoor antennas
• Connect the outdoor antenna cable lead-in to ANT (Antenna terminal) on the rear of the main unit.
F-type connector
75-ohm coaxial cable
LC-20S5U_E.indb 8 2005/12/15 11:18:36