Sharp LC 26D6U Flat Panel Television User Manual


 
15
Watching TV
Initial setup
When you turn on the TV for the first time, it will automatically memorize the broadcasting channels where you
live. Perform the following steps before you press TV POWER on the remote control unit.
1. Insert the batteries into the remote control unit. (See page 7.)
2. Connect the antenna cable to the TV. (See page 13.)
3. Plug in the AC cord to the AC outlet. (See page 6.)
CH Search
ANALOG [ ]25 [ ]20
FoundAir
CH Search
DIGITAL [ ]25 [ ]20
FoundAir
2
Air ANALOG
Audio : MONO
Language setting
Select from among 3 languages: English,
French and Spanish.
Press a/b to select the desired language
listed on the screen, and then press ENTER.
Antenna setting
Make sure what kind of connection is made with
your TV.
Press c/d to select “Yes” for ANALOG, then press b
to move down.
Press c/d to select “Yes” for DIGITAL (Air), then press
b to move down.
Press c/d to select “Yes” for DIGITAL (Cable), and
press b to move down.
Select “Search Start”, and then press ENTER.
This operation makes the TV search for both ANALOG,
DIGITAL (Air) and DIGITAL (Cable) channels.
ANALOG Yes
DIGITAL (Air)
No
Yes No
DIGITAL (Cable) Yes No
Language
Standby Mode
Air/Cable
CH Search
Search Start
CH Search
DIGITAL [ ]25 [ ]25
FoundCable
Example
NOTE
DIGITAL(Cable) setting cannot be selected when a proper
CableCARD security module is inserted.
1
Channel search
Channel auto search makes the TV look for
all channels viewable in the set area.
NOTE
Make sure what kind of connection is made with your TV.
If no channel is found, make sure what kind of connection
is made with your TV and try EZ setup again. (See page
21.)
Press c/d to select “Air”, “Cable” for ANALOG, then
press b to move down.
Press c/d to select “Standard”, “HRC” or “IRC” for
DIGITAL (Cable).
Press ENTER to enter the setting.
There are 3 kinds of CATV system, including Standard,
HRC and IRC. Select the one that matches to your TV.
2
Standby Mode setting
Select the standby setting. (See page 24.)
Language
Standby Mode
Air/Cable
CH Search
Mode 1
Mode 2
Mode 1: Starting TV is quick from standby.
Mode 2: Power consumption is small at the standby.
NOTE
When the CableCARD security module is inserted, power
consumption will be higher.
3
4
LC-32D6U(E)-013-015 05.8.8, 10:12 AM15