Sharp LC 26D6U Flat Panel Television User Manual


 
47
Other viewing options
Presetting remote control function
You can operate the connected AV products (AV
Receiver, Cable Box, SAT tuner, DTV, VCR, DVD, LD)
using the presetting manufacturer function for your
remote control unit.
Presetting manufacturer codes
Press FUNCTION until the LED for your
device lights up.
After the LED for your device lights up, if you
press FUNCTION and DISPLAY and enter
the code registration mode, the LED will
blink.
Press 09 to enter the manufacturer code.
(See page 48.)
Preset mode is finished once the LED no longer
lights up.
1
2
3
After registering the code, the LED will stop
blinking then turn off after one second. (If
you perform an incorrect operation, the LED
will blink quickly then turn off.)
4
Press FREEZE.
A moving image is captured.
Press FREEZE again to cancel the function.
NOTE
This function does not work in INPUT 4 (HDMI).
• When this function is not available, “No displaying still
image available” will display.
The still image is automatically erased after 30 minutes.
If you are using freeze function and a broadcast activates
the V-CHIP BLOCK, freeze function will be cancelled and
a V-CHIP BLOCK message will appear.
1
Freezing images
Allows you to capture and freeze an image from a
moving image that you are watching.
2
LC-32D6U(E)-046-052 05.8.8, 10:28 AM47