Filter
Top Products
43
Model
Input
PWR OSD Switch RC Pass-through
Start Remote Control Pass-through mode.
03
STB
NOTE
• Depending on the device connected, the On-Screen
Display of the connected i.LINK devices cannot be viewed
on the TV.
• You cannot view the On-Screen Display of the connected
device when the device is not connected with an i.LINK
cable.
• You cannot view the On-Screen Display of the connected
device when an analog signal is being received from the
connected device.
DTVLink
When the TV is connected to an i.LINK device such as
a digital STB/digital TV via the i.LINK cable, you can
view the On-Screen Display of the connected i.LINK
devices on the TV if the device supports this function.
DTVLink also allows you to control the connected
i.LINK devices using the TV's remote control without
displaying the i.LINK control panel.
Press i.LINK to display the i.LINK control
panel.
1
Press
c
/
d
to select “RC Pass-through”, and
then press ENTER.
• The message appears and the TV enters the RC
Pass-through mode.
• “RC Pass-through” will be displayed on the TV
screen for a few seconds when a designated
button for controlling the i.LINK device is
pressed.
OSD Switch
You can view the On-Screen Display of the connected
i.LINK devices on the TV.
Press
c
/
d
to select “OSD Switch”, and then
press ENTER to turn “OSD Switch” on or off.
• The “OSD Switch” status indicator turns green
when the “OSD Switch” is on.
• The “OSD Switch” status indicator turns red
when the “OSD Switch” is off.
2
Using external equipment
Remote Control Pass-through
You can control the connected i.LINK devices using
the TV's remote control without displaying the i.LINK
control panel.
• The remote control buttons that can be used with
Remote Control Pass-through during the “Pass-
through” mode are shown below.
NOTE
• To cancel RC Pass-through, press i.LINK on the remote
control.
• Depending on the device connected, RC Pass-through
cannot be used.
Press i.LINK to display the i.LINK control
panel.
1
The “OSD Switch” status indicator
2