Filter
Top Products
21
General
Settings
AV Settings
Languages
Parental Control
General
Auto Standby
Power Save in Standby Mode
Upgrade Software
Auto Retune
Auto Retune Messages
Manual Tune
First Time Installation
Enabled
Exit Menu
Select
OK
Exit
General
Auto Standby
This function allows you to automatically switch the
Receiver into standby mode when there is no user
activity for 3 hours.
Item
Enabled
The Receiver will automatically switch
into standby mode when there is no
user activity for 3 hours.
Disabled
The Receiver will remain on constantly
unless switched into standby mode by
the user.
General
Power Save in Standby Mode
This function allows you to control the power saving
features of your Receiver.
Item
Enabled
The receiver uses a very low amount of
power when in standby.
Disabled
Power saving features are disabled.
General
Upgrade Software
This function allows you to control when software
upgrades are installed.
Item
Automatic
The receiver will automatically install
software upgrades when available.
Manual
The receiver will display a message
allowing you to confirm or cancel the
software upgrade.
General
Auto Retune
This function allows you to control when new services
(channels) are added and stored on the Receiver.
Item
Always Start
Whenever new services (channels) are
detected, the Receiver will automatically
tune and store them.
Always Ask
Whenever new services (channels) are
detected, a message will appear on
screen. You can choose to tune and
store the new services or cancel the
auto retune.
General
Auto Retune Messages
This function controls when retune messages are
displayed.
Item
All
All messages are displayed.
No Minor
Messages
Only major messages are displayed.
Information Only
Only information messages are
displayed.
None
No messages are displayed.
NOTE
During the digital switchover, Auto retune messages may be •
displayed. Follow the on-screen instructions to retune.
Basic adjustment
TU-T2_GB.indd 21TU-T2_GB.indd 21 01/06/2010 16:03:1201/06/2010 16:03:12