Filter
Top Products
22
Basic adjustment
Manually tuning channels
General
Manual tune
You can manually tune new services after the first time
installation has been completed.
42
641787
8MHz
DVBT
UHF Channel
Frequency (kHz)
Bandwidth
System
Mode
FEC
NID
Systems Found / Added
Tuner Lock
Signal Strength
Signal Quality
2K
3/4
====
Guard
Mod
TSID
1/32
QAM16
====
==/==
Lock
Exit Menu
Watch
OK
Exit
Start Scan
Manual Tune
19%
40%
You can manually tune new services after the first time
installation has been completed.
Press 1 c/d to select the desired UHF channel.
Press
2 b to select ‘Frequency (kHz).
Press
3 c/d to adjust the frequency.
Press
4 b to select ‘Bandwidth’.
Press
5 c/d to adjust the ‘bandwidth’
Press 6 b to select ‘System.
Press
7 c/d to select a ‘System’.
Press the blue coloured button to start
8
scanning for the specified channel. If the
channel is found it will be stored in the
Receiver and will be available in the channel
list and EPG.
Item
UHF Channel
The channel number you want to save
the manually tuned channel as.
Frequency
The frequency of the service (channel)
you are manually tuning.
Bandwidth
The bandwidth of the service (channel)
you are manually tuning.
System
The type of tuning system
NOTE
You can enter the UHF Channel and Frequency using the 0-9 •
numeric buttons.
General
First time installation
This function allows you to perform a first time installation
(page 9).
TU-T2_GB.indd 22TU-T2_GB.indd 22 01/06/2010 16:03:1401/06/2010 16:03:14