Filter
Top Products
15
PROGRAMMING CHANNEL CONTROL LOCK
By default, the remote control’s channel-control
capabilities are locked to the cable converter. The
affected keys
*
are 1 through 0, CH+, CH-, ENTER, and
LAST. This will guarantee that you do not inadvertently
change a channel on your TV or VCR. However, you can
de-activate this feature to allow full access to these keys
in the TV and VCR modes.
*
NOTE: This feature does not affect the AUD mode.
Unlocking Channel Control
Now the remote control will provide TV and VCR
channel-control capabilities while in the TV or VCR
mode.
2. Press a mode key twice (i.e., AUX, DVD, AUD,
TV, or CBL) to clear all the learned keys for
that mode. The LED blinks twice.
3. Repeat step 2 for another mode or press and
hold SETUP to exit programming.
1. On the remote control, press CBL once; it will
blink once. Press and hold SETUP until the
CBL key blinks twice.
2. Enter 9 7 3. The CBL key will blink twice.
3. Press CH- once. The CBL key will blink four
times.
Atlas Shaw M1055FR Rev 1 Eng only.fm Page 15 Wednesday, October 5, 2005 5:28 PM