Filter
Top Products
SAC-00-094
Step 7: While listening to the meter, apply gentle
pressure to the top of the dish to move the dish – first
slightly downward, then upward to see if you can increase
the signal strength further. Carefully adjust the elevation
until you’ve maximized the signal. Tighten the Elevation
Adjustment Bolts.
Step 8: Repeat Steps 2-4 described in Fine Tuning
(Section 8) to obtain the highest reading possible on the
signal strength meter.
Step 9: The dish should now be peaked to its maximum.
Remove the Satellite Finder and plug the LNB directly
into the receiver. Confirm the signal strength by checking
the on-screen Tune in Satellite Signal box as described in
the previous section.
Your system is now fine tuned and ready for activation.
10. Grounding the Coaxial Cable
The Shaw Direct dish kit includes the following items to
ground the outdoor coaxial cable
• Coax cable connector Grounding Block
• Grounding Wire
• Grounding Clamp
Outdoor coaxial cable that may be subject to static
discharge or contact with electrical wiring, must be
grounded through a grounding block located as close as
possible to the cable entry point.
• Run the Grounding Wire for the coaxial cable from the
Grounding Block connector to a cold water pipe nearest
the cable entry point.
• Wrap copper grounding strap around cold water pipe.
Tighten strap using bolt and secure the ground wire
under the binding post nut as illustrated below
IMPORTANT : For more information on grounding
refer to the receiver’s User Guide included with your
Shaw Direct system.
10
Fig. Q
Ground block (shown with 2 coax cable feeds And ground
wire secured to binding post,)