Filter
Top Products
Preparing the Remote Controller
12
Remove the battery compartment cover by
pressing the tab and lifting up the cover.
Insert the two batteries (size AAA/R3).
Be sure to match the + and – ends of the batteries with
the diagram inside the battery compartment.
Replace the battery compartment cover.
Notes
• Do not mix new batteries with old batteries or different
kinds of batteries.
• To avoid corrosion, remove the batteries if the remote
controller is not to be used for a long time.
• Remove dead batteries immediately to avoid damage
from corrosion. If the remote controller does not
operate smoothly, replace both batteries at the same
time.
• The life of the batteries supplied is about six months
but this will vary depending on usage.
Point the remote controller toward the remote control
sensor.
Notes
• Place the unit away from strong light such as direct
sunlight or inverted fluorescent light which can prevent
proper operation of the remote controller.
• Using another remote controller of the same type in
the same room or using the unit near equipment which
uses infrared rays may cause operational interference.
• Do not put any object such as a book on the remote
controller. The buttons of the remote controller may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored
glass. Placing the unit behind such doors may prevent
proper remote controller operation.
• If there is any obstacle between the remote controller
and the remote control sensor, the remote controller
will not operate.
Inserting the Batteries Using the Remote Controller