Filter
Top Products
NOTE:
1
2
3
4
5
6
7
8
5
6
1
2
If your display has a curved back or a recessed thread mounting point, a spacer (M) must be used. Then choose screw
(F/G/H) to match.
Place the spacer (M) between the mounting bracket and display.
Next, drill holes using an electric drill and 5/16" masonry bit to a depth of 2".
Mark four holes to be used for securing the mount and place the wall plate aside.
b) Concrete/Brick Installation
The concrete anchors must be used for concrete installation.
Insert a concrete anchor into each hole.
Determine which screw (A/B/C/D/E/F/G/H) is of the correct length by
carefully inserting a straw, or toothpick, and mark how deep the
mounting point is.
Place your TV screen down on a soft, flat surface, and locate the
threaded mounting points that are located on the back of the display.
Step 2 Display Bracket Installation
If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall.
Then rotate the long screw at the bottom of the display rail to tighten.
Maintenance
Check the mounting screws every two months for tightness.
Begin by placing the wall plate into position against the wall, using the bubble level to keep it level.
Once all of the anchors are in place, move the wall plate back into position
Insert bolt (J) with washer (L) into each concrete anchor in the wall.
Do not tighten until all screws are in place.
To ensure optimal installation, this kit includes various screws of
different diameters and lengths.
According to the size of display's hole, choose the corresponding screw and hole on the rectangle washer, then thread
them in line as shown (figure 2-a)
4
1
2
3
Step 3 Final Installation & Adjustment
Hook the TV Rails over the top of the wall plate (figure 3-a).
4