Filter
Top Products
1
2
3
4
Figure 1 Figure 2
1
2
3
Step 1: Wall Plate Installation
Hold the wall plate (Figure 2) to the wall, use the two mounting holes to mark the
locations to be used for mounting the wall plate. Locate the holes directly into the
brick, block or concrete, never into the mortar between the blocks.
Pre-drill two holes to a depth of 2" using a 3/8" masonry drill bit at the positions you've
marked and insert one concrete anchor (B) into each hole.
Position the wall plate onto the wall again and insert the bolts (A) and washer (D) into
the anchor as shown (Figure 2) and tighten.
Use a high-quality electronic stud finder (commercially available) to locate dead center
of the wood stud and mark the location with a pencil.
Wood Stud Installation
Concrete/Brick Wall Installation
Attach the wall plate to the wall again and insert the bolts (A) and washers (D) into the
holes (Figure 1) and tighten.
Hold the wall plate (Figure 1) to the wall, use the two mounting holes to mark the
locations to be used for mounting the wall plate.
Take down the wall plate and drill two 2" deep holes, using a 1/8" drill bit at the
positions you've marked.
Page 2