Filter
Top Products
1
2
Figure 3
1
2
3
Figure 4
Phillips
screw driver
Figure 5 Figure 6 Figure 7
Step 3: Final Installation
Step 2: Display Plate Installation
Hang the display plate onto the top of the
wall plate and slip it into the wall plate as
shown (Figure 4).
Tighten the safety screw on the side and
back using a Phillips head screw driver
and the supplied 4mm Allen Key (Figure 5
& Figure 6 respectively).
Place your TV screen down on a soft, flat surface, and locate the threaded mounting
points that are located on the back of the display.
According to the size of the display's hole, choose the corresponding screw (E/F/G)
and washer (C) and insert into the hole as shown (Figure 3) and tighten.
Adjust the tension of the joint using the
supplied 6mm Allen Key (Figure 7).
Page 3