Filter
Top Products
SUR-47 User’s Manual Trouble Shooting
37
Problem Solution
The LCD screen turns off. The SUR-47 is preset automatically to switch
the LCD off after the Power Down time. Just
tap the SLEEP button to turn the SUR-47 back
on again. You can also reset the Power
Down time period (page 26).
One or more devices do
not respond in RF mode.
When operating properly, the red LED light
on the front of the base unit will blink while
sending or receiving signals. To test base
unit:
1. Press Remote Locator button.
2. Use remote in RF mode.
LED should blink during each test.
RF addresses for device(s) and base unit
may not set to the same setting. Check
setting on each and reset if needed.
Check to make sure SUR-47 is set to operate
in RF mode.
Base unit is not aimed at desired device. Re-
position base unit.
No AC power to base unit. Make sure AC
adapter is plugged in.
Batteries may be low in remote. Change
batteries if needed.