Filter
Top Products
11 | CHAPTER 2 – CABLING AN 885ix SYSTEM TO A HAWM-UX/UF
Connecting the SMART UX60 projector to the wire
management bundle (WMB)
SMART recommends that when the WMB isn’t in use, you use the WMB’s magnetic
connection to attach the WMB to the HAWM-UX/UF’s moving frame. By doing so, you
prevent the WMB from shifting as the HAWM-UX/UF rises and descends.
CAUTION
When attaching a guest computer or laptop to the projector system, make sure
that it is not pulled by the HAWM-UX/UF at its lowest or highest height.
NOTE
If you choose to connect the WMB to the wall-mounted magnetic clip, do so at a
height and location that doesn’t interfere with the HAWM-UX/UF’s movement.
To connect your
projector’s WMB
1. Connect the WMB to the projector by attaching the HD-DB15 connector to the
projector’s connection panel.
NOTE
The USB A plug doesn’t connect to the projector’s connection panel.
2. Place the WMB through the
cable management clip
located under the projector.
Make sure the WMB’s strain
relief sits above the clip
point.