Filter
Top Products
62 | CHAPTER 5 – CABLING A 600I4 OR D600I4 SYSTEM TO A HAWM-UX/UF
To connect your
projector’s network and
peripheral device cables
on the HAWM-UX/UF
1. If you don’t want to connect a network cable, proceed to step 3. Otherwise, make
sure you have a network cable with RJ45 plugs (not included) long enough to
connect your projector to a LAN port.
2. Pass the network cable through the boom and connect the RJ45 plug on the
network cable to the RJ45 port on the projector. Make sure that the network cable
is in the middle left position in the cable slot.
3. Pass peripheral device cables through the boom. Make sure that the peripheral
device cables are in the middle left position in the cable slot.
4. Connect your peripheral device cables to the appropriate locations on the
projector’s connection panel.
5. If you don’t want to connect a network cable, proceed to the next step. Connect
the RJ45 plug on the network cable to the RJ45 port on the projector, making sure
that the network cable is in the middle left position in the cable slot.
6. Secure the cable to the SMART UF65 or SMART UF65w projector’s wall-mount
bracket using a cable tie. Place the cables through the cable cutouts on the
bottom wall-mount bracket.
7. Place the cables
around the back of
the HAWM-UX/UF
toward the left side
of the interactive
whiteboard if the
peripheral device or
LAN port is located
on the left or toward
the right side of the
interactive
whiteboard if the
peripheral device or
LAN port is located
on the right.
8. Attach the cables to
the lower cable clips
on the HAWM.
9. If you have many cables attached, smoothly bundle your peripheral device cables
together using a cable tie (not included).
10. Attach a cable management clip (not included) to the cables or cable bundles,
making sure there’s a minimum of 28" (71.1 cm) excess straight length or a 14"
(35.6 cm) loose loop of cable.
Lower cable
clips
Cable management clips