Filter
Top Products
14 | CHAPTER 2 – CABLING AN 885ix SYSTEM TO A HAWM-UX/UF
Connecting your SMART UX60 projector to the pen tray
audio jack
The audio and power jacks are located beside each other on the back of the pen tray.
To connect the projector
to the audio jack
1. Connect the ends of the stereo Y cable to the VGA 1 and the VGA 2 inputs on
your UF65 or UF65w projector.
2. Connect the other end of the stereo Y cable to the audio jack on the back of your
interactive whiteboard’s pen tray.
Connecting the SMART UX60 projector to the SBA-L
Projection Audio System
The HAWM-UX/UF is designed to accommodate mounting the SBA-L Projection
Audio System directly to the interactive whiteboard. That way, when the speakers rise
and descend with the HAWM-UX/UF’s and interactive whiteboard’s movement, there’s
less risk of damage to the audio connection and power cables. Therefore, SMART
recommends that you don’t mount the projection audio system (SBA-L) speakers to
the wall.
Before connecting the audio system to the projector, you must install the speaker
brackets, speakers and speaker cable clips according to the SBA-L Projection Audio
System Installation Instructions (smarttech.com/kb/142552
).
To connect your projector
to your speakers
1. Retrieve the 3.5 mm jack to dual channel audio output (two RCA jacks) cable from
the SBA-L packaging. This is the audio connection cable. Attach the 3.5 mm jack
to the projector’s connection panel.
Audio
jack
Power
jack