Smart Technologies UF55 CRT Television User Manual


  Open as PDF
of 58
 
11 English
Installation
Installation
Turning On the Projector and Putting It
into Idle Mode
Turning On the Projector
1. Ensure that the power cord and video signal cable are
securely connected. The Power LED is solid Amber.
2. Turn on the lamp by pressing “
” on the remote control.
The Power LED turns green.
The startup screen displays in approximately 10 seconds.
3. Turn on your source. Select Input on the remote control
toselectaninputsource(VGA-1,VGA-2,Compositeor
S-Video).
The projector detects the source you select and displays the
image.
•Ifyouconnectmultiplesourcesatthesametime,press
Input on the remote control to switch between inputs.
Putting the Projector into Idle Mode
1. Press “ ” on the remote control to turn off the projector
lamp. A message appears on the interactive whiteboard.
2. Press “ ”againtoconrmyourselection.Ifyoudon’t
press “ ”again,themessagedisappearsafter 10
seconds.
Caution! Don’t turn on the projector immediately after
entering Idle Mode.
Thersttimeyou
usetheprojector,
you can select your
preferred language
from the main menu
after the startup
screen displays.
 previous next