Filter
Top Products
48
Test Tone
Selects the signal type for the HDMI OUT
jack.
b
Select “2ch PCM” when connecting a TV or an AV
amplifier (receiver) that does not support Dolby
Digital or DTS, otherwise noise or no sound may
result.
Selects whether to mix or not mix interactive
audio and secondary audio (commentary)
when playing a BD that contains such audio.
b
PCM 96 kHz and PCM 192 kHz audio signals are
output as PCM 48 kHz audio signals when “BD
Audio Setting” is set to “Mix.”
Lowers the audio output level to prevent
sound distortion.
b
“Audio ATT” does not affect the output from the
HDMI OUT jack and the DIGITAL OUT
(OPTICAL/COAXIAL) jack.
Selects the audio signals output when playing
Dolby Digital discs.
This setting affects the output from the
DIGITAL OUT (COAXIAL/OPTICAL)
jack.
Selects the audio signals output when playing
DTS discs. This setting affects the output
from the DIGITAL OUT (COAXIAL/
OPTICAL) jack.
On The player emits a test tone
in sequence from the
MULTI CHANNEL
OUTPUT jacks to adjust the
sound level from each
speaker. When you select
one of the “Speaker
Settings” items, the test tone
is emitted from the selected
speaker.
Off
The test tone is not emitted
from the speakers.
Audio (HDMI)
Auto Normally select this.
Outputs audio signals
according to the status of the
connected HDMI device.
2ch PCM Downmixes to 2-channel
Linear PCM signals before
outputting from the HDMI
OUT jack.
BD Audio Setting
Mix Outputs the audio obtained
by mixing the interactive
audio and secondary audio
to the primary audio.
Direct Outputs the primary audio
only.
Audio ATT
On Enables Audio Attenuation.
Off
Disables Audio Attenuation.
Dolby Digital
Downmix
PCM
Converts to output Linear
PCM signals. Select this
when connecting an audio
device without a built-in
Dolby Digital decoder.
Dolby Digital Select this when connecting
an audio device with a built-
in Dolby Digital decoder.
DTS
Downmix
PCM
Converts to output Linear
PCM signals. Select this
when connecting to an audio
device without a built-in
DTS decoder.
DTS Select this when connecting
to an audio device with a
built-in DTS decoder.