Filter
Top Products
46
GB
AFT Allows you to fine-tune the selected channel manually if you
feel that a slight tuning adjustment may improve picture
quality.
You can adjust the fine tuning over a range of –15 to +15.
When “On” is selected, fine tuning adjustments are made
automatically.
Audio Filter Improves the sound of individual channels when distortion
occurs in mono broadcasts. Sometimes a non-standard
broadcast signal can cause sound distortion or intermittent
sound muting in mono programmes.
If you do not experience any sound distortion, we recommend
that you leave this option to “Off” (factory setting).
~
• You cannot receive stereo or dual sound when “Low” or
“High” is selected.
Skip Skips unused analogue channels when you press PROG +/–
to select channels. To select channels you have programmed
to skip, use the corresponding number buttons.
Decoder Allows you to view and record the scrambled channel when
using a decoder connected directly to scart connector /
AV1, or / AV2 via a VCR.
~
• This option is not available when “United Kingdom” is
selected for “Country” (page 6).
LNA Improves the picture quality of the channel (noisy picture)
when the broadcast signal is very weak.
If you cannot see any improvement in the picture quality even
if you set to “On”, set this option to “Off” (factory setting).
Confirm Saves changes you have made to the “Manual Programme
Preset” settings.
Digital Set-up
Digital Auto Tuning Tunes in the available digital channels.
You can retune the TV after moving house, or to search for newly launched
channels.
Programme Sorting Allows you to remove or change the order of digital channels stored in the TV.
1 Press F/f to select the channel you want to remove or move to a new position.
You can also select a channel by pressing the number buttons to enter its
three-digit channel number.
2 Remove or change the order of the digital channels as follows:
To remove a digital channel
Press . After a confirmation message appears, press G to select “Yes”, then
press .
To change the order of the digital channels
Press g, then press F/f to select the new position for the channel and press G.
3 Press RETURN.