Filter
Top Products
Appendix A-29
Appendix
Function
Sub item
Item
REMOTE VIDEO
CONTROL MODE
0 ALL LINE
722
723
INPUT VIDEO
BLANK
[0]
1
[0]
1
2
[–––]
blank
throu
0: Blanking is specified for each line.
1: All lines selectable by this menu item are blanked, no
matter what the other sub item settings are.
2: All lines selectable by this menu item are not blanked, no
matter what the other sub item settings are.
Settable range
Item number
Specifies whether the blanking is on or off during the
vertical blanking of video input signal.
The blanking line can be selected independently. Y/C and
odd/even signals are blanked simultaneously. The input
signals blanked by specification of these sub items are
recorded on tape.
LINE 12
|
LINE 20
(DVW-A500/1
and 500/1)
12
|
20
0
[2]
0: Blanked
2: Not blanked
blank
[throu]
9
|
22
0
[2]
0: Blanked
2: Not blanked
blank
[throu]
LINE 9.32
|
LINE 22.335
(DVW-A500P/1
and 500P/1)
VIDEO INPUT
AGC/MANUAL
0
[1]
724
(with optional
BKDW-505 for
DVW-A500/1
and 500/1, and
BKDW-506 for
DVW-A500P/1
and 500P/1)
Sets the AGC to on or off (manual) for video input signal.
0: The AGC is on.
1: The AGC is off (manual).
AGC
[manual]
Set video input signal level when the item 724 is set to “1”.
0
|
[80]
|
FF
725
(with optional
BKDW-505 for
DVW-A500/1
and 500/1, and
BKDW-506 for
DVW-A500P/1
and 500P/1)
VIDEO INPUT
MANUAL LEVEL
0 (HEX)
|
[80HEX]
|
FF (HEX)
( )
H BLANKING
WIDTH
726
[0]
1
[narrow]
wide
Sets the horizontal blanking width of the video output signal.
When analog blanking is selected, the horizontal blanking
width conforms to the RS170A standard (for DVW-A500/1
and 500/1) or CCIR624-3 standard (DVW-A500P/1 and
500/1). Normally, a wide blanking width and a narrowed
picture are used. During editing, “0” is recommended; in
transmission, select “1” to output the signal in conformity
with the respective standard.
0: Digital (narrow) blanking
1: Analog (wide) blanking
Specifies the type of video process control via the Sony 9-
pin remote interface.
0: composite (Video, Chroma, Hue)
1: component (Y, P
B PR)
Note
Hue cannot be controlled in component mode via 9-pin
remote interface. Hue should be controlled by menu or by
BVR-50.
[composite]
component (Y-R, B)