Filter
Top Products
5-10 Chapter 5 Recording/Playback
5-4 Playback
Chapter 5 Recording/Playback
3 Set the search dial to center position for still-
picture, or press the STOP button to stop variable
mode playback.
To return to normal-speed playback
Press the PLAY button
To alternate between normal-speed playback
and variable mode playback
After you have set the search dial to the angle that
corresponds to the desired playback speed, pressing
the PLAY button or VAR button selects normal-speed
playback or variable mode playback, respectively.
To stop or start variable mode playback, press the
STOP button or VAR button, respectively.
The VTR is factory set to enter jog or shuttle mode
during playback whenever you rotate the search dial.
You can set the VTR through 101. SELECTION FOR
SEARCH DIAL ENABLE in the VTR SETUP menu
so that pressing the JOG, SHUTTLE, or VAR button
and then rotating the search dial activates the
respective mode.
5-4-3 Capstan Override Playback
When playing back the same program on two VTRs,
you can adjust the playback phases of the two VTRs so
that they are synchronized.
There are two ways to make this adjustment:
(A) Using the search dial
(B) Using the +/– buttons
Note
When using method (A), change the system setup so
that jog/shuttle mode playback is inhibited even when
rotaing the search dial. Doing so prevents the VTR
from accidentally entering jog/shuttle mode during
capstan override playback. Make this setting through
101. SELECTION FOR SEARCH DIAL ENABLE in
the VTR SETUP menu.
Capstan override playback
1(A)
1,2
1
(B)
1 Use either method (A) or (B).
(A)Rotate the search dial while holding down the
PLAY button to adjust the playback speed.
The adjustment range is ±15% (in steps of 1%)
of the normal playback speed.
(B)Press the + or – button while holding down the
PLAY button to adjust the playback speed.
While the buttons are pressed, the playback
speed increases or decreases by 8%,
respectively.
During playback at increased or decreased speed,
the SERVO indicator goes off since the servo is
not locked (capstan override).
2 Release the PLAY button after you have finished
adjusting the phase.
The VTR returns to normal-speed playback and the
SERVO indicator lights up.
5-4-4 DMC Playback
Overview of DMC playback
DMC (Dynamic Motion Control) playback allows you
to vary the playback speed between –1 and +3 times
normal speed for certain sections of the tape, then store
the specified speed in memory for later playback.
For example, during a live broadcast of a sporting
event, you can set the start and end points of important
scenes while recording, and immediately play back
and broadcast those scenes using DMC playback.
Before performing DMC playback
Set 111. PROGRAM PLAY in the VTR SETUP menu
to disable.