Filter
Top Products
21
GB
Watching TV
Viewing pictures from
connected equipment
Switch on the connected equipment, then
perform one of the following operation.
For equipment connected to the scart sockets using a
fully-wired 21-pin scart lead (page 40)
Start playback on the connected equipment.
The picture from the connected equipment appears on
the screen.
For an auto-tuned VCR (page 7)
In analogue mode, press PROG +/-, or the number
buttons, to select the video channel.
For other connected equipment (page 39)
Press / repeatedly until the correct input
symbol (see below) appears on the screen.
Additional operations
To use the Tools menu
Press TOOLS to display the following options when
viewing pictures from connected equipment other
than a PC.
* This option appears only if “i Speaker Link” is set to
“Off” (page 30).
AV1/ AV1, AV2/ AV2, AV3/
AV3:
Audio/video or RGB input signal through the scart
socket / 1, 2 or 3. appears only if an RGB
source has been connected.
AV4:
Component input signal through the Y, P
B/CB, PR/CR
sockets / 4, and audio input signal through the
L (MONO), R sockets / 4.
AV5:
Digital audio/video input signal through the HDMI IN 5
socket.
AV6:
Digital audio/video input signal through the HDMI IN 6
socket. Audio input signal is analogue only if the
equipment has been connected using the DVI and audio
out socket.
AV7 / AV 7/ AV 7:
Input symbols appear depending on the connected
equipment and the “AV7 Input” setting in the “AV Set-
up” menu (page 31).
AV7: Component input signal through the Y, P
B/CB,
P
R/CR sockets 7, and audio input signal through the
audio L (MONO)/R sockets 7.
AV7: Composite input signal through the video
socket 7, and audio input signal through the audio L
(MONO)/R sockets 7.
AV7: S video input signal through the S video
socket 7, and audio input signal through the audio
L (MONO)/R sockets 7.
PC:
PC video input signal through the PC socket, and
audio input signal through the PC audio socket .
To Do this
Return to normal TV
operation
Press the TV function button,
DIGITAL or ANALOG.
Access the Input
signal index table
(except for PC video
input signal)
Press to access the Input signal
index table. (Then, only in
analogue mode, press
g.) To
select an input source, press
F/f,
then press .
Options Description
Close
Closes the Tools menu.
PAP (or Single Picture)
See page 17.
Picture Mode See page 23.
Sound Mode See page 26.
Power Saving See page 29.
Sleep Timer See page 29.
i Volume* See page 30.
Auto Clock Set Allows you to switch to digital
mode and obtain the time.