Filter
Top Products
12
Getting Started
COMPONENT VIDEO OUT
Y
1
2
1
2
C
B/B-Y CR/R-Y
VIDEO OUT S VIDEO OUTDIGITAL OUT
COAXIAL OPTICAL
AUDIO OUT
WOOFER
1
RL
PCM/DTS/MPEG/
DOLBY DIGITAL
2
CD
INPUT
L
R
L
S VIDEO
AUDIO
VIDEO
R
INPUT
2+1 Channel Surround Hookups
Required cords
Audio connecting cord (not supplied) (1)
S video cord (not supplied) (1)
When connecting the cords, be sure to match the color-coded
cord to the appropriate jacks on the components: Red (right) to
Red and White (left) to White. Be sure to make connections firmly
to avoid hum and noise.
Monaural audio cord (not supplied) (1)
One for a subwoofer
White (L)
Red (R)
White (L)
Red (R)
This connection is for listening to the sound through the
left and right speakers of the TV, or speakers connected to
a receiver and the subwoofer. You can enjoy rich bass
frequencies by connecting a subwoofer. Refer to the
instructions supplied with the component to be
connected.
Set “SUBWOOFER” in “SPEAKER SETUP” to “YES” in
the setup display (page 57). Then set “FRONT SPEAKER
SIZE” to “TV” when you use the TV’s speakers, or to
“LARGE,” “MIDDLE” or “SMALL” when you use the
speakers connected to the receiver.
zYou can enjoy surround sounds even if you connect front
speakers only
You can use 3D sound imaging to create virtual rear speakers
from the sound of the front speakers (L, R) without using actual
rear speakers (Virtual Enhanced Surround). For details, see page
35.
To AUDIO
OUT
TV
Receiver (Amplifier)
To audio input
To S VIDEO
OUT
To S VIDEO input
To AUDIO
OUT
(WOOFER)
To audio input
or
To mains
Subwoofer
(Active type)
: Signal flow
CD/DVD player
Notes
You cannot enjoy a picture with an S video signal if your TV does
not conform to the S video signal. When your TV does not have
an S VIDEO input, connect the component via the VIDEO INPUT
connector using the video connecting cord (not supplied) instead
of the S video cord. For details, see page 8.
Refer to the instructions supplied with your TV.