Filter
Top Products
9
Getting Started
If you connect the player to a monitor or
projector having component video input
connectors that conform to output signals from
the COMPONENT VIDEO OUT (Y, C
B/B-Y, CR/R-Y)
connectors on the player
Connect the component via the COMPONENT VIDEO
OUT connectors using three video connecting cords (not
supplied) of the same kind. You will get a better picture.
Notes
• Refer to the instructions supplied with the component to be
connected.
• Do not connect this player to a video deck. If you do, noise
may appear in the picture.
• Depending on the TV or receiver (amplifier), sound distortion
may occur because the audio output level is high. In this case,
set “AUDIO ATT” in “AUDIO SETUP” to “ON” in the setup
display. For details, see page 65.
Connect
directly
VCR
TV
CD/DVD
player
COMPONENT VIDEO OUT
COMPONENT
VIDEO IN
C
B
/B-YYC
R
/R-Y
C
R
C
B
Y
CD/DVD player
Monitor or projector
with component video
input connectors
Setups for the player
Some setup adjustments are necessary for the player
depending on the TV or other components to be
connected.
Use the setup display to change the various settings.
For details on using the setup display, see page 56.
• To connect the player to a wide-screen TV
In the setup display, set “TV TYPE” in “SCREEN
SETUP” to “16:9” (default setting). For details, see page
60.
• To connect the player to a normal TV
In the setup display, set “TV TYPE” in “SCREEN
SETUP” to “4:3 LETTER BOX” or “4:3 PAN SCAN.”
For details, see page 60.
• If the color system of the TV is NTSC or DUAL
Since the color system of the player is set to NTSC, you
can use the player as it is.
• If the color system of the TV is PAL
To change the color system of the player to PAL, hold !
down while pressing X on the player. The power
indicator lights up in green and changes to red. Then
release X.
zYou can check the color system of the player
Press ! on the player and then press @/1 on the remote. The
power indicator lights up in green. When “NTSC” appears on the
front panel display, the color system of the player is set to NTSC.
When “NTSC” does not appear, the color system is set to PAL.