Filter
Top Products
Menu List
A-18 Appendix
Appendix
Specifies the type of editing for digital audio signals.
0: Cut editing (discontinuity in audio signal may result at the
join, causing noise.)
1: Cross-fade (see figure below.)
2: Fade-out and fade-in (see figure below.)
DATA No. 1
DATA No.2
Note
The “t” in the figures above is the time set by item 803.
FunctionItem Settable range
316
CONFIDENCE
PB MODE
Item number
Specifies the confidence playback mode when the [F2]
(CONFI) button in the HOME menu is set to ON.
0: VTR changes to CONFI playback mode during recording
and editing mode.
1: Same as Mode 1, except VTR changes to the confidence
playback mode also when EDIT preset is ‘ON’ during
normal playback.
2: Confidence control is operative only in crash recording
mode.
Note
When previewing during an automatic edit, the VTR
changes to ADVANCE playback mode no matter what this
item is set to.
0
[1]
2
AUDIO EDIT
MODE
317
0
[1]
2
cut edit
[crossfade]
fade in/out
0
[1]
Set this item when the VTR is used as a recorder during
VTR-to-VTR editing. Specifies the action taken when the
recorder fails to synchronize with the player VTR.
0: Editing is not executed and the VTR enters STOP mode.
1: The VTR automatically repeats the editing again (up to
two times twice).
318 EDIT RETRY off
[on]
319 PREREAD
SELECT
[0]
1
2
[audio/video]
audio only
video only
Specifies PREREAD operations.
0: Prereads both audio and video signals.
1: Prereads audio signals only.
2: Prereads video signals only.
Preread operations are specified and executed by the [F1]
(PRE READ) button in the HOME menu or a 9-pin
REMOTE1-IN connector command.
SYS 1,SYS 2 ROM
version 1.30 and higher
MODE 1 : Rec/Edit
MODE 3 : Rec only
IN/OUT
IN/OUT
t
t
MODE 2 : Rec/Edit/
E.preset