Filter
Top Products
Menu List
A-22 Appendix
Appendix
Item number Item FunctionSettable range
Specifies the signal output to the TIME CODE OUT
connector when the internal time code generator is in a
mode for regenerating the playback time code (i.e., when
the [F6] (TCG SOURCE) button in the TC menu is set to int
and the [F7] (TCG MODE) button is set to regen, or when
the VTR is in the automatic edit mode).
0 :The playback time code signal is output to the TIME
CODE OUT connector without regeneration.
1 :The playback time code signal is output to the TIME
CODE OUT connector after regeneration only when the
VTR is in playback mode.
606 [0]
1
TC OUTPUT
SIGNAL IN REGEN
MODE
607
[0]
1
2
3
4
5
6
7
[000:notspecified]
001: iso character
010: unassigned-1
011: unassigned-2
100: unassigned-3
101: page/line
110: unassigned-4
111: unassigned-5
Specifies the user bit in the time code signal that is
generated by the time code generator.
0: Character setting is not specified.
1: 8-bit character in compliance with ISO 646 and ISO
2022.
2: Unassigned
3: Unassigned
4: Unassigned
5: Page/line multiplexed system of SMPTE 262M
6: Unassigned
7: Unassigned
U-BIT BINARY
GROUP FLAG
608
PHASE
CORRECTION
[0]
1
[off]
on
[off]
on
auto
[0]
1
2
TCG CF FLAG
Specfies whether the color frame (CF) flag is set (ON) or
not set (OFF) in the blank bit of the time code data.
0: Color frame flag is set OFF.
1: Color frame flag is set ON.
2: Color frame flag is set ON or OFF depending on the
phase relationship of the color framing between the
recorded video signal and the time code signal.
Note
When this item is set to “2”, the color frame flag is
determined by the operating mode of the time code
generator.
• When INT PRESET mode (i.e., the EXT/INT switch is set
to int, the REGEN/PRESET switch to prst, and the VTR is
in a mode other than automatic edit mode), the time code
signal is generated with color frame-locked to the video
signal, and the color frame flag is ON.
• When INT REGEN mode (i.e., when the EXT/INT switch
is set to int, the REGEN/PRESET switch to regen, and
the VTR is in automatic edit mode), or EXT mode (i.e.,
EXT/INT switch is in ext), color frame flag is OFF.
609
[offtape]
regen
Specifies whether the phase correction control of the LTC
signal generated by the time code generator is applied or
not.
0: The phase correction control is not applied.
1: The phase correction control is applied.