Filter
Top Products
88
Other Info SETUP WelcomeSETUP SETUPSETUP
General
Problem Possible Remedies
How to reset TV to
factory settings
❏ Turn on the TV. While holding down the RESET button on the remote
control, press the POWER button on the TV. (The TV will turn itself off, then
back on again.) Release the RESET button.
How to restore Video settings
to factory settings
❏ Press the RESET button on the remote control while in the Video Menu (see
page 66).
How to restore Audio
settings to factory settings
❏ Press the RESET button on the remote control while in the Audio Menu (see
page 68).
Cannot cycle through the
other video equipment
connected to the TV
❏ Be sure the Video Label option is not set to Skip (see page 78).
Cannot operate Menu ❏ If a menu option appears in gray, this indicates that the TV is in a state in
which the menu option is not available.
Lost password ❏ In the password screen (see page 74), enter the following master password:
4357. The master password clears your previous password; it cannot be
used to temporarily unblock channels.
TV makes “popping” sound
when turned on
❏ This is a normal sound that results from the TV automatically degaussing
each time it is turned on.
LED on front panel is lit ❏ The STAND BY LED (see page 11) blinks when the TV is turned on, then
shuts off when the picture is displayed. If the LED blinks continuously, this
may indicate the TV needs service.
❏ The TIMER LED (see page 11) indicates that the timer is set (page 79).
When the timer is set, this LED will remain lit even when the TV is turned
off.
Digital cable box does not
work
❏ Be sure that you have not connected the digital cable box to the TV’s TO
CONVERTER jack. This jack is not compatible with digital cable boxes.
❏ If you are connecting a VCR and digital cable box using a splitter, as
described on pages 24-25, you must use a special bi-directional splitter that
is designed to work with your digital cable box. Contact your cable
provider for details.
34XBR.book Page 88 Friday, February 7, 2003 4:03 PM