Filter
Top Products
71
Editing with another VCR
Additional Operations
filename[010addo.fm] model name1[SLV-SE250B] model name2[SLV-SE450B]
[3-868-346-E2 (1)]
Operation (when recording on this VCR)
Before you start editing
• Turn on your TV and set it to the
video channel.
• Press CHOIX ENTREE to display
“L1” or “L2” in the display
window.
• Press SP/LP to select the tape
speed, SP or LP.*
To stop editing
Press the
x
STOP buttons on both VCRs.
Tip
• To cut out unwanted scenes while editing, press
X
(pause) on this VCR when an unwanted
scene begins. When it ends, press
X
(pause) again to resume recording.
Note
• If you start editing following the procedure above, the VCR won’t start recording with the
OPC function. To record a tape with the OPC function, press
z
ENR again during recording
pause in step 3 so the VCR analyses the tape. Then, press
X
(pause) after
the OPC indicator
stops flashing to start recording. If you press
X
(pause) before
the OPC indicator stops
flashing, the OPC function is cancelled.
* SLV-SE450B only
1
Insert a source tape with its safety tab removed into the other (playback) VCR.
Search for the point to start playback and set it to playback pause.
2
Insert a tape with its safety tab in place into this (recording) VCR. Search for the
point to start recording and press
X
(pause).
3
Press
z
ENR on this VCR to set it to recording pause.
4
To start editing, press the
X
(pause) buttons on both VCRs at the same time.
X
z ENR
010COV.book Page 71 Friday, April 14, 2000 1:07 PM