Filter
Top Products
20
Remote Control
Insert two size AA batteries (supplied) by matching e and E on
the batteries to the diagram inside the battery compartment of the
remote control.
~
• To avoid possible damage from battery leakage, remove the batteries if you anticipate the remote control will not be
used for an extended period.
• Handle the remote control with care. Avoid dropping it, getting it wet, or placing it in direct sunlight, near a heater, or
in high humidity.
Inserting Batteries into the Remote Control
,
Button Descriptions
Button Description
1 DISPLAY Press once to display the information pertaining to the
channel and/or program when available. The OSD (On
Screen Display) will time out in a few seconds or press again
to immediately turn off the display. You can also set the
display to show minimal information. See Info Banner on
page 42.
2 SLEEP Press repeatedly until the TV displays the time in minutes
(Off, 15min, 30min, 45min, 60min, 90min or 120min)
that you want the TV to remain on before shutting off. To
cancel Sleep Timer, press SLEEP repeatedly until Off
appears.
3
FUNCTION
Buttons
The FUNCTION button indicator lights up momentarily
when pressed to show which external equipment the remote
control is operating. When the remote control is set to
operate the external equipment, these buttons will operate
the equipment you choose. You must first press one of these
FUNCTION buttons to operate the corresponding
equipment. See page 25 for “Programming the Remote
Control”.
4 0-9 ENT Press 0-9 to select a channel; the channel changes after two
seconds. Press ENT to change channels immediately.
5 Use with 0-9 and ENT to select digital channels.
For example, to enter 2.1, press , , and ENT.
~
•The 5, PLAY and CH + buttons have a tactile dot. Use them as a reference
when operating the TV.
1
2
3
4
5
2
1