Sony KDF-WE655 series Projection Television User Manual


 
Other Information
125
Other Information
KDF-WE/WF655
2-059-370-14 (2)
General
Problem Possible Remedies
How to reset TV to factory
settings
Turn on the TV. While holding down the RESET button on the remote control,
press the POWER button on the TV. (The TV will turn itself off, then back on
again.) Release the RESET button.
How to restore Video settings
to factory settings
Press RESET on the remote control while in the Video menu (see page 98).
How to restore Audio settings
to factory settings
Press RESET on the remote control while in the Audio menu (see page 102).
Cannot cycle through the other
video equipment connected to
the LCD projection TV
Be sure the Label Video Inputs option is not set to Skip (see page 113).
Cannot operate Menu If a menu option appears in gray, this indicates that the menu option is not
available.
Lost password In the password screen (see page 108), enter the following master password:
4357. The master password clears your previous password; it cannot be used to
temporarily unblock channels.
TIMER/STANDBY LED on
front panel is lit
The LED (see page 24 or 126) blinks when the TV is turned on, then shuts off
when the picture is displayed. If the LED blinks continuously, this may indicate
the TV needs service. When lit, indicates that the timer is set (see page 24 or 126).
When the timer is set, this LED will remain lit even when the TV is turned off.
Digital cable box does not work If you are connecting a VCR and digital cable box using a splitter, as described on
page 41, you must use a special bi-directional splitter that is designed to work
with your digital cable box. Contact your cable provider for details.
Cannot record digital channels
to VCR
Only analog channels can be recorded to your VCR.
The replacement lamp does not
light up
The screw of the lamp cover may be slanted. Take out the screw, insert it straight
into the screw hole, and then tighten it completely (see page 19 for KDF-WE655
series, see page 22 for KDF-WF655 series).
TV cabinet creaks When the TV is in use, there is a natural rise in temperature, causing the cabinet to
expand or contract and may be accompanied by a slight creaking noise. This is not
a malfunction.
01COV.book Page 125 Thursday, February 17, 2005 8:01 PM