Sony KDL-40SL150 Flat Panel Television User Manual


 
Getting Started > Connecting the TV > PC
PC
Use the TV as a monitor for your PC by connecting a HD15-HD15 cable as shown below. This TV can also be connected to a PC with a DVI or HDMI output.
(Refer to the separate Quick Setup Guide.)
PC and HDMI Input Signal Reference Chart
After connecting the PC to the TV, set the output signal from the PC according to the supported resolutions and timings indicated below.
Connect the PC IN jack to the PC using an HD15- HD15 cable with ferrite core (analog RGB) and audio cable.
If the PC is connected to the TV and no signal has been input from the PC for more than 5 minutes, the TV enters the standby mode automatically. Refer to
the PC Power Management option under Setup Menu
.
Supported Resolutions Horizontal
frequency (kHz)
Vertical
frequency (kHz)
Standard
Signal Horizontal (Pixel) x Vertical (Line)
VGA 640 x 480 31.5 60 VGA
SVGA 800 x 600 37.9 60 VESA Guidelines
XGA 1,024 x 768 48.4 60 VESA Guidelines
WXGA 1,280 x 768 47.8 60 VESA
1,360 x 768 47.7 60 VESA
SXGA 1,280 x 1,024 64.0 60 VESA
HDTV 1,920 x 1,080 67.5 60 CEA-861
This TV’s PC input does not support Sync on Green or Composite Sync.
This TV’s PC VGA input does not support interlaced signals.
Adjust Phase to eliminate horizontal lines of the picture when the TV receives an input signal from the connected PC.
Back to HD Cable Box/HD Satellite Box Next to Other Equipment
Home | Getting Started | Operating the TV | Using Features | Using the Menus | Other Information | Specifications
Copyright © 2009 Sony Electronics Inc. All rights reserved.
Getting Started Operating the TV Using Features Using the Menus Other Information Specifications