Sony KDL-46S4100 Flat Panel Television User Manual


 
Getting Started
13
Getting Started
Connecting the TV
Cable System or
VHF/UHF Antenna
System
You can enjoy high-definition and standard-definition digital programming
(if available in your area) along with standard-definition analog
programming.
Cable or VHF/UHF (or VHF only)
Cable System and
VHF/UHF Antenna
System
Use an optional A-B RF switch (not supplied) to switch between the cable
and over-the-air antenna programming, as indicated below.
This TV is capable of receiving unscrambled digital programming for
both cable (QAM and 8VSB) and external VHF/UHF antenna (ATSC).
It is strongly recommended that you connect the CABLE/ANTENNA
input using a 75-ohm coaxial cable to receive optimum picture quality. A
300-ohm twin lead cable can be easily affected by radio frequency
interference, resulting in signal degradation.
75-ohm coaxial cable Rear of TV
CABLE/ANTENNA
Be sure to set the Cable setting to On or Off in the Channel settings for
the type of input signal you choose (see page 31).
B
A
Cable
Antenna
A/B
RF Switch
Rear of TV
CABLE/ANTENNA