Filter
Top Products
30
GB
AV Setup menu
You can select the options listed below on the AV
Setup menu. To select options in “Settings”, refer to
“Picture menu” (page 21).
Video Labels
Assigns a name to any equipment connected to the side and rear jacks. The name will
be displayed briefly on the screen when the equipment is selected. You can skip an
input source that is not connected to any equipment.
1 Press
F/f to select the desired input source, then press .
2 Press
F/f to select the desired option below, then press .
Equipment labels: Uses one of the preset labels to assign a name to connected
equipment.
“Edit”: Creates your own label. Follow steps 2 to 4 of “Program Labels” (page 31).
“Skip”: Skips an unnecessary input source.
Video 1 Auto S Video
Selects the input signal from S video jack 1 when / 1 jacks are both
connected.
“On”: Switches automatically between the S video jack and the composite video
jacks on the rear of the TV depending on the cable connection.
“Off”: Activates the composite video jacks on the rear of the TV.
Video 2 Input
“Auto”: Switches automatically between the component video jacks, S video jack,
and the composite video jacks on the left side of the TV depending on the cable
connection.
“Component”: Activates the component video jacks on the left side of the TV.
“S Video”: Activates the S video jack on the left side of the TV.
“Composite”: Activates the composite video jacks on the left side of the TV.
Tip
When multiple cables are connected and “Auto” is selected, “Component”, “S
Video”, “Composite” will be activated in that order.
Color System
Selects the color system (“Auto”, “PAL”, “SECAM”, “NTSC3.58” or “NTSC4.43”)
according to the input signal from the input source.
Game Mode
Depending on the game software, reaction times may slow during fast-moving
scenes, etc. Select “On” to improve the reaction times.
Color Matrix
Usually used in the factory setting (Video 1/2 (Composite and S video input signal)/
3 is set to “ITU601”, and Video 2 (Component input signal)/HD/DVD 1/2/HDMI 1/
2 is set to “Auto”). If the tone of the picture from the input source is unnatural, select
either “ITU601” or “ITU709”, which normalizes the tone.