Filter
Top Products
83
Welcome SETUP Other InfoSETUP SETUPSETUP
Channels
General
Problem Possible Remedies
Cannot receive upper
channels (UHF) when
using an antenna
❏ Change the Cable option to Off (see page 68).
❏ Use Auto Program in the Channel Menu to add receivable channels that are
not presently in the TV’s memory (see page 68).
TV is fixed to one channel ❏ Use Auto Program in the Channel Menu to add receivable channels that are
not presently in the TV’s memory (see page 68).
❏ Check your Channel Fix settings (see page 68).
Cannot receive any
channels when using
cable TV
❏ Use Auto Program in the Channel Menu to add receivable channels that are
not presently in the TV’s memory (see page 68).
❏ Make sure the Cable option is set to On in the Channel Menu (see page 68).
Cannot receive or select
channels
❏ Use Auto Program in the Channel Menu to add receivable TV channels that
are not presently in TV memory (see page 68).
Problem Possible Remedies
How to reset TV to
factory settings
❏ Turn on the TV. While holding down the RESET button on the remote
control, press the POWER button on the TV. (The TV will turn itself off, then
back on again.) Release the RESET button.
How to restore Video settings
to factory settings
❏ Press the RESET button on the remote control while in the Video Menu (see
page 64).
How to restore Audio
settings to factory settings
❏ Press the RESET button on the remote control while in the Audio Menu (see
page 66).
Cannot cycle through the
other video equipment
connected to the TV
❏ Be sure the Video Label option is not set to Skip (see page 75).
Cannot operate Menu ❏ If a menu option appears in gray, this indicates that the TV is in a state in
which the menu option is not available.
Lost password ❏ In the password screen (see page 70), enter the following master password:
4357. The master password clears your previous password; it cannot be
used to temporarily unblock channels.
TV makes “popping” sound
when turned on
❏ This is a normal sound that results from the TV automatically degaussing
each time it is turned on.
LED on front panel is lit ❏ The STAND BY LED (see page 11) blinks when the TV is turned on, then
shuts off when the picture is displayed. If the LED blinks continuously, this
may indicate the TV needs service.
❏ The TIMER LED (see page 11) indicates that the timer is set (page 73).
When the timer is set, this LED will remain lit even when the TV is turned
off.
36_40XBR.book Page 83 Tuesday, April 16, 2002 4:16 PM