Filter
Top Products
41
SETUP Setup SETUPSETUP SETUPSETUP
Setting Up the Channel List
After you finish connecting your TV, you need to run Auto Setup to
set up your channels. The Auto Program screens appear when you
turn on your TV for the first time after hooking it up.
Using Auto
Program
To run Auto Program the first time you turn on your TV
1 Press POWER to turn on the TV.
The Initial Setup screen appears.
2 Using the joystick on the remote control, move the highlight to
the desired language, then press to select that language.
3 The next screen instructs you to connect your cable/antenna.
Check that you’ve connected your signal source as described on
pages 16 to 22.
To start Auto Program, move the joystick to highlight
Yes and then
press .
Auto Program automatically creates a list of receivable channels.
When Auto Program is finished, the Tilt Correction screen
appears.
4 Move the joystick B b to correct any tilt of the picture. You can
choose a correction between +7 and -7.
When finished, press . The Vertical Correction screen appears.
5 Move the joystick V v to make a vertical correction to the picture.
You can choose a correction between +5 and -5. When finished,
press .
The lowest numbered channel is displayed.
To reset the TV to factory settings
1 Press POWER to turn on the TV.
2 Hold down RESET on the remote control.
3 Press TV POWER on the TV. (The TV will turn itself off, then back
on.)
4 Release RESET.
To exit the Tilt Correction
and Vertical Correction screens,
press the MENU button.
z
For more details on using
Auto Program, see page 84.
For more details on using Tilt
Correction and Vertical
Correction, see pages 89-90.
z
34XBR.book Page 41 Monday, May 19, 2003 8:44 AM