Filter
Top Products
– 18 –
KV-T29SN81
RM-870
3-3. FOCUS ADJUSTMENT
Adjust FOCUS control on the flyback transformer for the best
focus.
Note: Screen VR is not use.
a. AN ITEM OF ADJUSTMENT
b. METHOD OF CANCELLATION FROM SERVICE
MODE
Set the standby condition (Press [POWER] button on the commander)
and then press [POWER] button again, hereupon it becomes TV
mode.
c. METHOD OF WRITE FOR MEMORY
1) Set to Service Mode.
2) Press 1 (UP) and 4 (DOWN) to select an item of adjustments.
3) Press [MUTING] button and it will indicate WRITE on screen.
4) Press - button to write into memory.
d. MEMORY WRITE CONFIRMATION METHOD
1) After adjustment, pull out the plug from AC outlet, and then
plug into AC outlet again.
2) Turn the power switch ON and set to Service Mode.
3) Call the adjusted items again, confirm they were adjusted.
NoteInitial DATA
09 RDR 25 WHITE POINT R
0A GDR 20 WHITE POINT G
0B BDR 20 WHITE POINT B
3-4. G2 (SCREEN) AND WHITE BALANCE
ADJUSTMENTS
1. G2 (SCREEN) ADJUSTMENT (RV701)
1) Set the PICTURE and BRIGHTNESS to normal.
2) Put to VIDEO input mode without signals.
3) Connect R, G, and B of the C board cathode to the oscilloscope.
4) Adjust G2 (RV701) volume to the value below.
2. WHITE BALANCE ADJUSTMENTS
1) Set the Service Mode.
2) Input an entire white signal.
3) Set the PICTURE to maximum.
4) Select RDR(09) with 1 and 4 , and then set the level to 25
with 3 and 6 .
5) Select GDR(0A) and BDR(0B) with 1 and 4 and adjust
the level with 3 and 6 for the best white balance.
6) Write into the memory by pressing [MUTING] → then - .
0 V
177 ± 2 V DC
SERVICE
MUTING
1 F
DATA
RDR
Adjustment Item
09
Item number
WRITE1 FRDR09
0
Executes the writing
Focus
Item
number
Adjustment
item
180 V DC